Toyota C-HR Forum banner
1 - 10 of 10 Posts

· Registered
Joined
·
45 Posts
Discussion Starter · #1 ·
Hi
Now using my CHR in the dark as winter approaches. Does anyone else think that the front headlight beam is low when on dipped? Is there any way of raising it slightly - i know that some cars have a switch to raise and lower the lights. Hope this makes sense. Thanks
 

· Super Moderator
Joined
·
1,962 Posts
maybe if they are set to low already ,pages 246 in the manual ,unless you have leds(dynamic)
 

· Registered
Joined
·
30 Posts
I asked my dealer the same question last week when I got my C-HR. LED's are not adjustable, at all, - as they should auto-balance depending on load of the car and so on. I also thought mine was dipped a little too much, - but the answer was "no way we can adjust those". They are auto adjusting, - not all the time/instantly, - but they might occasionally be too high, - or too low depending on... everything... for a little while that is until they re-adjust.

Kim Igel.
 

· Registered
Joined
·
4 Posts
Your dealer is wrong. When I mounted loweringsprings, I needed to adjust the light. There is white plastic bracket with holes on each side if you open the hood. And then you have to have a really really long screwdriver.
 

· Super Moderator
Joined
·
1,962 Posts
@Alfred uk spec dynamic has led lights which adjust automatically ,which your car is not, standard lights can be adjusted manually from within the car( pages 246 in the manual) or re-aligned with a screwdriver from under the bonnet
 

· Registered
Joined
·
4 Posts
I have what you call it in Sweden Hybrid Executive with tech package on my car with led all around and the auto adjust is on the back axle. But because I lowered my car the position sensor changed quite a bit. I was in the garage of my dealer and adjusted the light.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top